This little adapter lets you use Hakko T12/T15 tips on your TS100 soldering iron.  (T12/T15 are the same, just for different markets)  Of course, your iron will be longer, but the upshot is that the Hakko tips can be had for cheaper, and the little rubber grip on the Hakko has a lot better feel than the body of the TS100.
The adapter includes a built-in stand.
I was able to print it without any supports by printing with the stand end face down.  Once you are done, slide the rubber grip on a Hakko tip and click it into place, and then click the adapter into the rubber tip.  Loosen the Allen bolt on the iron and slide it into the iron.  It'll only fit one way.  Lock it down gently with the Allen bolt and you're good to go.  This area on the iron does not heat up, so printing with PLA is just fine.
Included is the Solidworks source file.

Помочь в развитии канала
Яндекс деньги 410011964334974
QIWI карта 4890494696855568
WebMoney R880221591443 Z115671410823
Сравнение двух знаменитых паяльников TS100 VS T12. Моё мнение
-----------------------------------------------------------------------------------------------
Паяльная станция http://ali.pub/2e1uxj
------------------------------------------------------------------------------------------------
TS100 http://ali.pub/2e1rfx Banggood http://bgd.by/2e1rmj
-------------------------------------------------------------------------------------------------
Подробное видео по созданию моей станции https://youtu.be/Eik94_Xxk0E
Список необходимых деталей для самодельного изготовления
Кит набор паяльника http://ali.pub/1qonei Banggood http://got.by/1shwcn
Блок питания 24 вольта http://ali.pub/1qoni0 Banggood http://got.by/1shylq
Термофен http://ali.pub/1qonli Banggood http://got.by/1sjp39
Разъём для термофена http://ali.pub/1qonsw
Плата от кит набора паяльника http://ali.pub/1qonyj Banggood http://got.by/1shx4u…