Today, I will show you how to assembly anti z-wobble for Ender 3/Ender 3 Pro.Design was made based on: https://www.youtube.com/watch?v=mqSQhwqSzvg&ab_channel...

This is remix from Heavy Duty e3dv6, but with more stable Bltouch.
Аll original modules from HeavyDuty fit with my remix

This is a single piece adapter to upgrade your  Creality CR-10 or Ender-3 printing head to direct extruder.
You will need:
1) 1x BMG extrude
2) 1x Short (23mm) extruder motor (overwize motor will hit X-axis casing)
3) 1x V6 hotend with 30mm axial cooler
4) 1x 5015 turbine blower
5) 2x countersunk M3x10 (or 12) screws (they goes in two holes highlighted by red arrows)
Blower can be fixed by itself. Screw is not necessary.
Printing:
1) Orientation is as shown
2) Supports are not needed
3) Shell walls 1.2 mm or more (to make the print harder), top/bottom 3-4 layers
4) Infill 20-25%
5) High temperature materil is strongly recommended (ABS or PETG). PLA will melt near hot end.
Installation:
1) Disassemble the head to bare cariage.
2) Attach the adapter plate by two M3x10(12) screws (as the red arrows shows)
3) Assemble BMG with V6 together (I assume that the throat, heatblock, nozzle, heating cartridge and temperature sensor are on V6 already)
4) Attach V6 heatsink
5) Attach 23mm motor and BMG extruder to the adapter…