Клуб обладателей 3D-принтера Ender-3; Ender-3x и  Ender-3 Pro https://ender3.club Если у вас проблема и вы ищете совета то: 1) Распечатайте калибровочную модель:  https://vk.com/album-26626593_269583825  Дефекты лучше всего различимы на сером пластике. 2) Прикрепите несколько фото и/или видео. 3)..

Smarter Shopping, Better Living!  Aliexpress.com

Last updated: Dec. 10, 2020 (see Change log section near the bottom of this post)
A simple, lightweight, compact, and easy to print direct drive mount for BMG extruders, V6 hotends, and ABL setups. This is compatible with open carriage printers such as an Ender 3 (Pro/V2), Tevo Tornado, Alfawise U20, etc.
This excellent design is originally made by Adolf_Muffin, but I made a couple of improvements:
M3 nut mounting holes and screws.
Better BLTouch mount - the original was fragile and it would hit the tension belt adjuster at max X.
Better cable route on Carriage Mount -  moved the original cable route from the right to the left.
List of screws and nuts needed.
Guides for Slicing, Assembly, Firmware Config, and Calibration.
— — — — — — — — — — — — — — — — — — — — — — — — — —
Quick note about the components:
• This mount should be compatible with GENUINE or CLONE components.
• As of July 20, 2020, the carriage mount and BLTouch mount does not fully support the Ender 5. The current models can work, but you're going…