What is this thing?
This is a remix of TrevM's Mini Drawers. The original design is great but I needed some improvements. Thankfully, TrevM provides the *.scad-files, so the required changes could be made using OpenSCAD:

The runners did not fit perfectly in the slots. I think it depends on your 3D printer how snuggly these pieces fit together. I added a global variable "runnersDiameter" to the corresponding *.scad-files so adjusting the runner's diameters is quiet easy. I was fine with 2.85mm.


To prevent the drawers from falling out when pulling too far I added a small stopper on the top/front inside of the house.


Added magnet holes to the house's and drawer's backside. While the aforementioned stopper prevents pulling a drawer too far, the magnets prevent the drawer from sliding when a house is moved or tilted.


The handles were too delicate for my fingers so I made them oval and increased their protrusion.


To minimize elephant feet I added chamfers to the bottom of the drawer and handle using the Chamfered…