А в целом у тебя стандартный набор

Мне очень кажется что прописав полиси, я вырубил 4

о. прикольно. Такую не юзал

bond_miimon 100
bond_mode 4
bond_downdelay 200
bond_updelay 200
bond_lacp_rate 1
bond_xmit_hash_policy layer3+4

мой конфиг

Но тогда это первый бонд мод, с этой полиси

4 же, это 802.3ad

Allows you to specify the bonding policy. The value can be one of:
balance-rr or 0 — Sets a round-robin policy for fault tolerance and load balancing. Transmissions are received and sent out sequentially on each bonded slave interface beginning with the first one available.
active-backup or 1 — Sets an active-backup policy for fault tolerance. Transmissions are received and sent out through the first available bonded slave interface. Another bonded slave interface is only used if the active bonded slave interface fails.
balance-xor or 2 — Transmissions are based on the selected hash policy. The default is to derive a hash by XOR of the source and destination MAC addresses multiplied by the modulo of the number of slave interfaces. In this mode traffic destined for specific peers will always be sent over the same interface. As the destination is determined by the MAC addresses this method works best for traffic to peers on the same link or local network. If traffic has to pass through a single router then this mode of traffic balancing will be suboptimal.
broadcast or 3 — Sets a broadcast policy for fault tolerance. All transmissions are sent on all slave interfaces.
802.3ad or 4 — Sets an IEEE 802.3ad dynamic link aggregation policy. Creates aggregation groups that share the same speed and duplex settings. Transmits and receives on all slaves in the active aggregator. Requires a switch that is 802.3ad compliant.
balance-tlb or 5 — Sets a Transmit Load Balancing (TLB) policy for fault tolerance and load balancing. The outgoing traffic is distributed according to the current load on each slave interface. Incoming traffic is received by the current slave. If the receiving slave fails, another slave takes over the MAC address of the failed slave. This mode is only suitable for local addresses known to the kernel bonding module and therefore cannot be used behind a bridge with virtual machines.
balance-alb or 6 — Sets an Adaptive Load Balancing (ALB) policy for fault tolerance and load balancing. Includes transmit and receive load balancing for IPv4 traffic. Receive load balancing is achieved through ARP negotiation. This mode is only suitable for local addresses known to the kernel bonding module and therefore cannot be used behind a bridge with virtual machines.
For details about required settings on the upstream switch, see Section 7.6, “Overview of Bonding Modes and the Required Settings on the Switch”.

@Sensiductxfcc че обсуждаете не понимаю)

4 да, но читай выше

.

Ты сказанул про бонды, вот я и вспомнил

Ничесе, ад починил?

Не моя зо

Хе хе

Кароч 3+4 не полностью соответствует стандарту

Вот как хоч так и понимай

Но при использовании XOR траефик не ходит по двум интерфейсам, поэтому, гранату в руки и прописываем хэш полиси

ребята, кто может помочь в развертывании проекта на стеке MERN (mongoDB, express, react, node.js)? Приобрел домен с хостингом,  запустил приложение на сервере, но страница не отображается. Если есть желание могу по zoom связаться