K3D VOSTOK 3D printer. Contribute to dmitry-sorkin/K3D-VOSTOK development by creating an account on GitHub.

Surgical Mark Strap(16/04/20) updated:
Hi, friends.Thanks for the reply (especially Myrandor), I had a modified version uploaded:
1, 1.5 mm thickness
NO round corner
Hook enhanced
Can attach hair clips to fix the position
Surgical Mark Strap(11/04/20) updated:
Firstly, thanks to all who remixed and/or printed my strap design. I didn't expect it to be this popular. However, many are racing to print as many as their print bed allows and most have asked me if there is any way of increasing the print density. The answer is, YES (sort of).
During breakfast with https://www.thingiverse.com/F96, he mentioned that you could stack two designs vertically and then peel them off like supports, so long as the designs are just flat to begin with. However, the "air-gap" between the bottom and top must be baked-into the 3D model, typically supports have an air-gap of 0.35mm for 0.2mm layer height prints. After some tests, it seems to work just fine.
So here is a version stacked as a pair. Try printing this, and if it works for…