Chuck shows you how to setup Cura Tree Supports vs Simple Supports and all the settings in this episode. He uses a simple test print to see which Cura support works best and why. He shows how easy they are to remove and how well the print looks when done. If you want to learn how to use Tree Supports or Standard Supports in Cura then watch this episode of Filament Friday.

Creality Ender 3:
From Banggood : https://bit.ly/2wfD5Ia  
From   : https://amzn.to/2VoA4zV  
From Gearbest : https://bit.ly/2re9iQe

Cura Slicer:
https://ultimaker.com/en/products/ultimaker-cura-software

Support Test Print: https://www.thingiverse.com/thing:3232756

Filament Friday Tool Kit: https://amzn.to/2MOR00X
Filament Friday Filament: https://amzn.to/2rgz3Ma

Temperature Meter Used in Videos: https://amzn.to/2JpUJOC
Screwdriver set used in Videos: https://amzn.to/2PbWocM

Creality Ender 3/CR-10 Parts:
———————————
PTFE Coupling: https://amzn.to/2BJDog1
Capricorn Tubing: https://amzn.to/2nI2ipS
CR10/Ender3 Silicon Heater Block Cover:…