Test cube for new filaments.
It's designed to print fast, use only a small amount of filament and give you a good first impression of what you can expect your finished prints to look like.
Includes different features like small holes & pins, overhangs, bridges and small letters.
Printtime between 30 minutes and 1 hour.
Uses about 5 grams / 2 meters of 1.75mm filament.
Measurements:
20mm side length
Horizontal hole: 10mm diameter
Vertical holes/pins: 6mm/2mm diameter, 10mm height/depth
Rectangular hole (Bridge test): 5mm width, 4mm height