28-06-2018 - People are having issues trying to obtain the Pin 27 adapter board, there is another way around this which is a little more complicated but doesn't require the board here http://jonathanlundstrom.me/2017/10/23/cr-10-bltouch-firmware/
26-06-2018 - Added version 3 to add suggested changes to CR-10/Ender 3 section to make things more clear, use this version instead of v1 or v2!
25-06-2018 - Added a version 2 of the guide due to issues in v1, this addresses most of the issues below with more photos and screenshots to look at for installation, you should definitely use this instead of v1!
I've tried to make this guide as simple as possible with all the resources you need in one place or linked to it, sections include;
Before you start
Printers
CR-10s /S4/S5/Mini
Ender 2
Ender 3/CR-10  
Configuring Z offset    
Start-up GCODE
CR-10/s
Ender 2
Ender 3
Misc & Extras
Remove all boot screens for faster boot times
Control ooze while bed levelling runs (Simplify3D)
CR-10 stock to CR-10s board
This guide was…

View this cool model on 3D Geeks: Thingiverse browser