Maximum Z height with direct drive!
This clips on the cover for the  Ender 3 series (including V2)  X axis end stop. Apparently also works for the Mingda d2. Whoda thunk it?
It comes in two pieces and is joined with an M3x16 screw and nut.
Created to get my direct drive cable management under control.
Updated for orientation.
The orientation should now be correct and you just need supports to build plate.
It would be great if you would post your make so we can see how  your setup looks like!
Direct Drive Adapter https://www.thingiverse.com/make:914608
Cooling Hero Me 5 https://www.thingiverse.com/make:914617

EDIT V2:
Added a round version with 6 magnets per side. 4 will receive bearing balls and the two protruding without. The two magnets are meant to help the pieces realign / aid lateral movement instead of spin with the lead screw.
END EDIT V2
There's been a few of these popping up on Thingiverse and the idea is based on MirageC's work https://www.youtube.com/watch?v=mqSQhwqSzvg. I've gone and made my own for the  Anycubic Mega Zero since the ones available so far are far too big.
Here's a video of these: https://youtu.be/MiLdzWd_OEo
They are meant for 16mm lead screw nuts. Let me know if you need 18mm mounting holes.
You will need:
(12) 6x3mm neodymium magnets.
(4) 1.5 - 3mm ball bearing. I pulled mine from an LM8UU linear ball bearing guide.
(2) 8mm M3 nut for the lead screw.
(2) 8-10mm M3 nut for the top piece depending on the thickness of your Z bracket plate.
I haven't had a chance to test these since I am out of the right size m3 screws. They are intended to be screwed in directly and no need for m3 nuts.…